User's Manual

3
Examples of auxiliary
accessories (optional)
HSE03
playlist of
Clipboard
Stop Stop playing the
selected song
(Clipboard only)
Play Play the selected
song
(Clipboard only)
Delete Delete a song
from the playlist
(Clipboard only)
Exit Exit HSE03.exe
Save As Save selected
songs to another
directory or
location
Volume
Control
(Low / Mid /
Hi)
Adjusts the
volume of songs; it
determines the
volume of HSE03
If you wish to keep the preset songs, it is recommended
you make a copy of them before carrying out the following
steps. To save the preset songs, press
; to
download songs to HSE03:
1. Select a folder where the songs are stored in
Navigation Pane.
2. Select song/songs you wish to download to the Bell
from List Pane.
3. Press
to add selected song/songs to the
Clipboard. If storage capacity in Clipboard has
exceeded the limit, a warning indication will be shown
(FIGURE 11); likewise, you can refer to the capacity
indicator for the percentage of being occupied storage.
4. Once you’ve completed song selections, press
to download selected songs to the Bell. A saving
prompt box will appear while data is saving (FIGURE
12).
SETTING
In order to communicate with other security accessories,
the HSE03 needs to learn the ID code of other accessories,
and vice versa.
Learning ID Code
1. Press the learning key “D” (as shown in page 1) for
more than 3 seconds and release, during which the
green LED will flash at 2-second interval repeatedly.
This implies HSE03 is now entering the ID code
learning mode. Green LED will flash repeatedly
representing the unit is waiting for receiving the ID
code signal of another accessory.
2. Within 30 seconds, press the learning key of another
accessory (don’t press HSE03 learning key anymore).
This step allows HSE03 and the accessory to emit and
learn the ID code mutually. When a green LED keep
on 1 sec. and then stop flash it implies the ID code
learning procedure is completed and success
Note:
Only one accessory ID code can be learned at a time.
HSE03 can store up to 12 sets of ID codes (including its
own code). If there is more than one accessory ID code
needs to be learned, simply repeat the above steps.
3. Learning outcome:
Indicator Status
LED
Green LED illuminate for
1 seconds & turn off
Successful
LED
Green LED flash 4 times
(0.1 second on, 0.1 second off)
Failed
Note:
No ID code has been preset when first time you operate
HSE03. After insert the batteries, Green LED will flash at
2-second interval repeatedly.
Operation Mode
The mode of HSE03 is accessory mode , and all control
command come from Controller like Gateway HSC06
Figure 3.
Illustration of ID code learning between SE802
and cooperative accessories.