User Manual

Addendum User Manual: Chrosziel Zoom Servo Drives

How to correctly power the motor and how to use different zoom modes

Steps to connect zoom servo drives to the camera

Before you start:

Check the LANC cables in the box. The improved cables should have a length of 13,78” (35

cm) – if not, please contact Chrosziel or your favored dealer immediately.

Please make sure all cables are correctly connected before you power the setup!

First: connect all LANC cables with the motor and the camera

Second: connect the LEMO connector with the power port at the zoom servo drive

Third: connect the D-Tap (or any other power cable) with the battery

Fourth: make sure the D-Tap connector is inserted correctly

THEN: switch on the power

Cable connecting:

Bottom of the motor (left to right):

LEMO compatible 0B 5-Pin (camera

start / stop, power)

2.5 mm Jack (control command in / out)

USB type mini A-B (firmware updates)

Plug-in the LANC control cables into

the zoom servo drive. Both ports can

be used.

PAGE 1
Addendum User Manual: Chrosziel Zoom Servo Drives How to correctly power the motor and how to use different zoom modes Steps to connect zoom servo drives to the camera Before you start: Check the LANC cables in the box. The improved cables should have a length of 13,78” (35 cm) – if not, please contact Chrosziel or your favored dealer immediately.
PAGE 2
Connect the LANC extension cable of the zoom servo drive with the LANC cable of the Sony handgrip and the other LANC cable with the LANC port of the camera. Connect the LEMO compatible 0B 5Pin cable to the motor. Connect the D-Tap plug with the battery of the camera. Make sure the D-Tap connector is inserted correctly After you switch on the power the zoom servo drive starts auto -calibrating and looks for the end stops of the lens. As soon as the status LED is green you are set.
PAGE 3
Steps to switch the zoom modes You can choose the different modes by pressing the zoom rocker for round about 25 seconds, then the green LED flashes very fast while changing the zoom mode and after that it blinks 1, 2, 3 or 4 times* – depends on the zoom mode you chose (* 1 = EB / Documentary / 2 = Silent / 3 = Live / Hard Cut / 4 = Direct). To cycle through these all you need to do is hold the zoom rocker down one way for a couple of seconds to switch to the next mode, and the other way, hold to reverse.