Service Manual

Page 8
BaTTerY inforMaTion - draW TeST Procedure
This picture shows a complete setup for a Draw Test:
Note the black probe attached to the negative terminal and the red probe attached to the
negative battery cable.
This picture shows a typical multimeter. Note the current range switch settings and
current probe jack markings are all in yellow for uA (Microamps), mA (Milliamps and A
(Amps).
Also note that the meter has two Jacks for current measurement, “20A” and “uA/mA”. On
this meter, for our Draw Test, we would place the Function Switch in the “A” (for Amps)
position and plug the Red Probe into the “20A” Jack. The Black Probe always goes in the
Black Jack.