Operating instructions

Page 18
OPERATION
Power Ramp Operation
7KHSRZHUUDPSLVDFWLYDWHGE\
the electronic control system
using any of the control switches
LGHQWLÀHGRQSDJHV:KHQ
a control switch is activated to
start the Open functions, the
ramp deploys after the power
sliding door reaches the fully
open position. When the Close
functions are activated, the ramp
VWRZIXQFWLRQEHJLQVLPPHGLDWHO\
(simultaneously with the kneel
system).
If a control switch is activated
while the ramp is in motion
(deploying or stowing), the ramp
motor will stop running. Activat-
ing a control switch again will
start the Close functions (ramp
will stow, vehicle will raise and
the door will close).
1RWH7KHSRZHUVOLGLQJGRRU
must travel from the full closed
position to the full open position in
order for the ramp to deploy.
1RWH,IWKHYHKLFOHWUDQVPLVVLRQ
is disengaged from Park “P” while
the ramp is deploying (in motion)
or when the ramp is in the fully
deployed position, the ramp will
stow immediately.
1RWH,IWKHSRZHUUDPSLVRE-
structed while deploying or stow-
ing, the ramp motor will stop run-
QLQJSURYLGHGLWPHHWVVXIÀFLHQW
resistance. Press a control switch
again and the ramp will stow and
the door will close.
1RWH:KHQGHSOR\LQJWKHUDPS
the ramp motor stops running
when the ramp reaches the nearly
horizontal position (approximately
Allow ramp to deploy
fully before boarding.
Failure to do so may
result in damage.
DERYHJURXQGOHYHO7KH
ramp continues to slowly lower
WKHUHPDLQLQJGLVWDQFHE\WKH
force of gravity.
Forcing the Ramp: Allow the
power ramp to deploy (unfold
DQGORZHUIXOO\EHIRUHERDUGLQJ
the ramp. Forcing the ramp out
RUGRZQGXULQJWKHGHSOR\VWRZ
IXQFWLRQVRUERDUGLQJRQWRWKH
UDPSEHIRUHLWLVIXOO\GHSOR\HG
may result in damage to the
UDPSPRWRUDVVHPEO\DQGRU
electronic controller.