Owner`s manual

Automatic Transmission – If Equipped
Lubricant Selection
Refer to “Fluids, Lubricants, and Genuine Parts” in
“Maintaining Your Vehicle” for further information.
Fluid Level Check – Ram Truck Only
The fluid level should be checked when the engine is
fully warmed up and the fluid in the transmission is at
normal operating temperature. At normal operating tem-
perature, the fluid cannot be held comfortably between
the fingertips. Operation of the transmission with an
improper fluid level will greatly reduce the life of the
transmission and of the fluid. Check the fluid level
whenever the vehicle is serviced.
To properly check the automatic transmission fluid level,
the following procedure must be used:
1. Operate theengine at idle speed and normal operating
temperature.
2. The vehicle must be on level ground.
3. Fully apply the parking brake and press the brake
pedal.
4. Place the shift lever momentarily into each gear posi-
tion ending with the shift lever in PARK.
5. Remove the dipstick, wipe it clean and reinsert it until
seated.
6. Remove the dipstick again and note the fluid level on
both sides. The fluid level should be between the “HOT”
(upper) reference holes on the dipstick at normal operat-
ing temperature. Verify that solid coating of oil is seen on
both sides of the dipstick. If the fluid is low, add as
required into the dipstick tube. Do not overfill. After
adding any quantity of oil through the oil fill tube, wait
a minimum of two minutes for the oil to fully drain into
the transmission before rechecking the fluid level.
124 MAINTAINING YOUR VEHICLE