Owner`s manual

“Electronic Vehicle Information Center (EVIC)” in “Un-

derstanding Your Instrument Panel” for further informa-

tion. When engine temperatures fall below 66°F (19°C)

the “Wait To Start Light” will remain on indicating the

intake manifold heater system is active.

Follow the steps in the “Normal Starting” procedure

except:

1. The “Wait To Start Light” will remain on for a period

of time (length of time depends on engine temperature).

CAUTION!

If the “Water in Fuel Indicator Light” remains on, DO

NOT START engine before you drain the water from

the fuel filter to avoid engine damage. Refer to

“Maintenance Procedures/Draining Fuel/Water Sepa-

rator Filter” in “Maintaining Your Vehicle” for fur-

ther information.

2. After the “Wait To Start Light” goes off, turn the

ignition switch to the START position. Do not press the

accelerator during starting.

CAUTION!

Do not crank engine for more than 15 seconds at a

time or starter motor damage may result. Turn the

ignition switch to the OFF position and wait at least

two minutes for the starter to cool before repeating

start procedure.

3. After engine start-up, check to see that there is oil

pressure.

4. Allow the engine to idle about three minutes until the

manifold heaters have completed the post-heat cycle.

5. Release the parking brake and drive.

STARTING AND OPERATING 39