User Manual

CODE SWITCH
1.CODE SWITCH: Codes are set by pushing dip switches up or down. It is imperative that the code used
for both transmitter and receiver is exactly the same, otherwise remote controller will not work. Please
note the code switch will enable you to operate a second remote controller independently. For example, if
you have two ceiling fans with 2 remote control units, set 2 different codes for each set of
transmitter/receivers. This means you can operate each ceiling fan independently.
2.Your remote control is ready for use after battery installation.
FUNCTIONS OF TRANSMITTER POWER
POWER : Turn on or off the fan and light. or light 30s dealy. FAN SPEED
FAN SPEED : Turn on the fan at high ,med,low,
l.low speed,or fan off. LIGHT
1/f :The fan will turn at
natural wind mode 1/f
TIMER:The fan will turn off after 2 or 4 or 8 hours. TIMER
LIGHT:Press and release immediately to turn on or off the light.
Press and hold to dim or brighten lights to the desired
level and release. .
Ceiling Fan Remote Control
Wiring Connection
TR240A