Installation Guide

Tools required/Hardware
kit includes
x2
5/8”
(1.58 cm)
or/o/ou
1
1
2
2
1
Place seat on bowl
Attach nuts, nger-tighten
1
3
As you hold seat centered
on bowl, tighten lower
section of STA-TITE® nuts
until they snap off
1
Prior to seat installation, pre-shear off
bottom section of (1) nut using two
5/8” wrenches as shown. Discard
lower portion of nut, keeping upper
section with integrated washer for
installation on restricted acess side
of bowl. Do NOT Shear remaining nut
at this time.
2
Position sheared off nut directly
beneath the side with restricted
access bolt hole and as bolt is
coming through bolt hole, nger-
tighten nut to bolt, pulling it through
hole as it is being threaded. Finger-
tighten remaining nut on opposite
side of bowl.
1
3
Holding seat centered on bowl, use
a 5/8” wrench to tighten unsheared
nut until lower portion of nut shears
off. Use an open ended 5/8” wrench
and tighten pre-sheared off nut 4-5
quarter turns, this will indicate proper
tightening torque.
Alternate installation instructions for 1.28gpf bowls with restricted space

Summary of content (1 pages)