User manual

32
This device allows user to set the remote mode.
3.11.1.1 Press ” Up ” or “ Down ” to choose REMOTE MODE setup
3.11.1.2 Press ” ENTER ” to confirm REMOTE MODE setup
3.11.1.3 Press ” Up ” or “ Down ” to choose Interface for REMOTE MODE setup
RS-232: Use RS-232 interface
RS-485: Use RS-485 interface
3.11.1.4 Press ” MENU ” to exit and confirm current operation.
3.11.1.5 Press ” MENU ” again to exit and close REMOTE MODE setup mode.
3.11.2 Remote protocol Transmitting Baud Rate setup
This device allows user to set the remote protocol transmitting baud rate.
3.11.2.1 Press ” Up ” or “ Down ” to choose Baud Rate setup.
3.11.2.2 Press ” ENTER ” to confirm
3.11.2.3 Press ” Up ” or “ Down ” to choose BAUD RATE setup
115200、57600、19200、9600、4800、3600、2400、1200
3.11.2.4 Press ” MENU ” to exit and confirm current operation.
3.11.2.5 Press ” MENU ” again to exit and close BAUD RATE setup mode.
3.11.3 Remote protocol ID setup:
This will allow user to control different DQR by setting RS232 or RS485 remote protocol.
ID number can be set from 000 to 255.
3.11.3.1 Press ” Up ” or “ Down ” to choose ID setup.
3.11.3.2 Press ” ENTER ” to confirm ID setup
3.11.3.3 Press ” Up ” or “ Down ” to set numerical number, from 000 ~ 255
3.11.3.4 Press ” MENU ” to exit and confirm current operation.
3.11.3.5 Press ” MENU ” again to exit and close ID setup mode.