Operating Manual Ciclomaster Kabellos/Wireless Digital 2.
Table of contents Content Page . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Page 6. Functions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Functions in the upper display . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 1.
A A-1 A-2 B Congratulations on your purchase! By purchasing the CICLOMASTER CM 8.2 you have acquired an electronic multifunctional sports computer with the highest level of precision and newest digital transmission technology. The CM 8.2 has a state of-the-art electronics, is waterproof and convinces through his high durability. It’s special feature: Transmission from transmitter to device is implemented on a digital communication level and this makes it extremely faultresistant. The CM 8.
2.1 Mounting of optional cadence-set Mount the handlebar unit as described above. Place the transmitter on the cable in front of the crank (don‘t fasten cable-ties yet). Mount the cadence-magnet on the crank (max. distance 3 mm). Important! The magnet must point directly towards the mark on the transmitter. Now switch CM 8.2 cadence measuring on and - if not done yet - initialize the transmitter (see chap.5). Turn the crank a few times to check if the mounting has been done correctly so that CM 8.
SPD INISCAN To start this function, simultaneously press the left and right buttons briefly, jump setting with left button. To initialize the speed transmitter (for first use or after battery/transmitter change): First, activate the speed transmitter (by moving the magnet close to the transmitter where marked) then press the left and right buttons simultaneously. A percentage will be displayed in the upper display. If transmitter has been initialized successfully, the next setting option will be displayed.
Clock / Zeit Adjustment of the clock format Default: 24 Set with right button, store with left button Here you can select between 24- or 12-hour format (AM/PM). In order to calculate the CICLOInZone® position the chest belt correctly, take up a rest position (remain seated and relaxed) and start the CICLOInZone® calculation by short pressing of right and left button simultaneously. The CM 8.2 will then start to time 5 minutes. During this time, stay seated, relaxed and calm, as the CM 8.
The CM 8.2 has an automatic start/stop moving sensor. By mounting CM 8.2 in the handlebar bracket, this function will be activated. With the first movement of the bike, the display will be switched on and starts searching for the transmitter (to search transmitter manually press right button for 3 seconds). SPD TM by pressing the right button for 3 seconds.
km/h TM 1 8 9 15 Ø – Average Cadence TM SPD 1 TM SPD 1 km/h km/h SPD Indicates the average cadence. Range: 0 to 250 rpm 1 SPD km/h km/h km/h 16 MAX – Maximum Cadence 22 km/h TM SPD SPD TM DST SPD km/h km/h TM SPD TM SPD TM km/h SPD km/h TM km/h km/h km/h 8 4 TM TM SPD SPD SPD 18 SPD SPD SPD SPD TM TM SPD 1 TM Ø - Average Heart Rate km/h km/h 1 1 1 Subfunction of “Heart Rate” 1 km/h km/h 1 Indicates the average 1 km/h km/h heart rate (since last km/h km/h reset).
10. Trouble shooting 9. Battery change Faulty or no display - check to see if battery is installed properly or replace battery (Attention: removing battery will clear all settings and values) - press AC-button on the rear of the computer CM 8.2: First you should put CM 8.2 into the “Powerdown Mode” (see chapter 5 Settings) Open battery cap with a coin (unscrew to the left). Insert battery type CR2032 (please use battery with smooth minus-pole) with plus-pole facing up.
11. Guarantee Guarantee certificate: We offer a guarantee for 2 years from the date of purchase on the CM 8.2. The guarantee is limited to material and processing faults. Broken transmitters, or damages of wasted parts of CM 8.2 are excluded from the guarantee. The guarantee is valid only if the computer, with accessories, has been handled and maintained carefully and according to operating instructions.
