Operating instructions

28 29
The sex will then flash on the display
(“M” for male, “F” for female).
Press the Set button to change from
one value to another.
Store the value using the Mode
button. Set the weight using the Set
button.
The range of values is: 20 - 199 kg
or 50 - 500 lb
(The unit of measurement kg/lb
depends on the calendar format set).
Store the value using the Mode
button and the CicloInZone calcu-
lation will appear on the display.
Press the Mode button to switch the
calculation of the CicloInZone either
on or off and store using the Mode
button.
If the CicloInZone calculation is
switched off, now the display for the
manual setting of the heart rate limits appears (see point
'manual setting of the heart rate limits' below).
If the CicloInZone calculation is
switched on, the fitness level
selection will now appear on the
display (FitLvL).
Press the Set button to insert a
value from 1 to 4, corresponding to the following levels:
1 – poor fitness
2 – average fitness
3 – good fitness
4 – high fitness
Store using the Mode button and now the CicloInZone
calculation starts.
4.3 Adjustment of heart rate limit values and
switching heart rate acoustic alarm signal on/off
Here it is possible to calculate the personal CicloInZone
(or set upper and lower heart rate limits manual). If these
limits are exceeded, the CP 13is emits an optical alarm
signal (the heart rate display will flash) and (when
activated) an acoustic alarm, too.
Press the Mode button several times
until the stopwatch appears at the
top of the display.
Press and hold the Mode button for
3 seconds. The heart rate acoustic
alarm signal adjustment (WS =
Warning Signal) will flash on the
display.
Press the Set button to switch the
acoustic alarm signal either ON or
OFF.
Press the Mode button to store the
value and the date of birth will
appear on the display and the year
will flash.
Change the value displayed with the Set button and store
using the Mode button.
The month will then flash on the
display.
Change the value displayed with the
Set button and store using the Mode
button.
The day will then flash on the
display.
Change the value displayed with the
Set button and store using the Mode
button.
02 CP13is englisch 22-39 31.08.2005 9:40 Uhr Seite 8