Operating instructions

32 33
- training times below the lower limit
values set for the heart rate.
- average heart rate (Av) (changes
every 2 seconds)
- maximum heart rate (MA)
The stored values may be cancelled
in the stopwatch mode (ref.
subsection 5.2).
5.4 Graphics display
The CICLOPULS CP 13is also offer the possibility to
obtain a graphics display of the exertion within the set
heart rate zone in the central part of the display.
The blue segments turn black (from left to right) with a
heart beat within the heart rate zone. The number of black
segments depends on the current heart rate. If all the blue
segments have turned black, the heart rate measured is
higher than the upper limit.
If the heart rate measured is below the lower limit, only the
first two segments will turn black.
5.5 Switching beep sound on/off
The CICLOPULS CP 13is heart rate monitor is fitted with
an optical alarm signal:
the heart rate value flashes if the lower or upper heart rate
limits set are exceeded.
and an acoustic alarm signal:
an acoustic alarm sounds if the lower or upper heart rate
limits set are exceeded.
The acoustic alarm signal may be switched on and off in
To start the stopwatch, select the stopwatch function by
pressing the Mode button and then press the Set button
(the memory function will be started at the same time).
Press the Set button again (in stopwatch mode) to stop the
stopwatch (and also the memory function).
The times recorded within the set limits may be recovered
in the Memory mode (ref. subsection 5.3) by repeatedly
pressing the Set button.
To reset the stopwatch to zero (and, at the same time, the
training times, average and maximum heart rates), press
and hold the Set button for 3 seconds in the stopwatch
mode.
Warning: this will also cancel the stored values.
Whilst the values are being recorded, it is always
possible to recall another function without stopping
the stopwatch.
The stopwatch works up to a maximum value of 23:59:59
hours. When this value is reached the stopwatch will stop.
5.3 Memory Mode
Press the Set button several times
to recover the values stored. The
current heart rate is always shown
at the same time in the lower part of
the display.
The following information appears on the display:
- training times within the limit
values set for the heart rate
- training times above the upper
limit values set for the heart rate
02 CP13is englisch 22-39 31.08.2005 9:40 Uhr Seite 12