User's Manual

INSTALLATION

Caution: You must use a Class 2 power adapter that supplies

9 Volts DC and delivers at least 300 mA. Its center tip must

be set to positive and its plug must fit the phone’s DC 9V jack.

The supplied adapter meets these specifications. Using an

adapter that does not meet these specifications could damage

the phone or the adapter.

NOTE

For the longest battery life it is important that you follow

the instructions below:

■ Before connecting the telephone line cord, plug the AC adapter

into the wall socket and the phone.

■ Charge the battery pack for at least 12 hours.

■ After charging the phone, connect the telephone line cord and

use the phone as described in this manual.

WALL MOUNTING

Your new CL915 telephone may be installed on the studs of a standard

wall phone plate or on to two screws (not included) fastened into the wall.

When installing screws into plasterboard walls, use wall anchors (not in-

cluded) to insure that the screws remain secure. Insert the screws into

the wall leaving 3/16” of each screw extending out from the wall.

Mounting the Base on a Wall Plate

1. Remove the handset from the base.

2. Turn the base over so the underside of the base faces you.

3. Place the pedestal in the wall mount position and slide into place.

■ If mounting over a telephone wall jack, plug the supplied short

telephone cord into the jack labeled TEL LINE on the telephone.

Thread the line cord through the slot on the back of the phone

and plug the other end of the cord into the wall jack.

■ If wall mounting with screws, plug the supplied long telephone

line cord into the jack labeled TEL LINE on the telephone and

plug the other end of the cord into the wall jack.

4. Insert the AC adapter into the 9V DC jack on the bottom of the base.

5. Slip the telephone base onto the wall, lining up the wall mounting

holes over the wall plate posts or screws. Slide the telephone base

down so it is firmly in place.

6. Return the handset to the telephone base.

7. Plug the other end of the AC adapter into the AC outlet.

CL915.book Page 7 Friday, May 4, 2001 11:35 AM