Installation Instructions Part 3

BASE UNIT Control

1. TELEPHONE LINE CONNECTION JACK

2. BASE UNIT ANTENNA

3. RING SELECT Switch: To select the number of rings before the Answering System

answers a call.

3R - System answers a call after third ring.

5R - System answers a call after the fifth ring.

TS (TOLLSAVER) - System answers after the third ring only if you have new message.

Otherwise, the system will answer after the fifth ring.

4. MESSAGE ALERT Switch: Set switch to ON to generate a “beep” sound every 15

seconds when a new message has been received.

5. POWER-IN CONNECTION JACK

6. TONE/PULSE Select Switch

7. RINGER ON/OFF Switch: Set switch to OFF position to disengage the ringer on the

BASE UNIT.

8. ANNOUNCEMENT ONLY/INCOMING MESSAGE Switch:

ICM - System records the incoming messages.

ANNC- System plays your announcement and then hangs up without recording

messages.

BASE UNIT Controls

IMPORTANT

Placing your BASE UNIT near appliances such as

televisions, refrigerators, radios, or microwave ovens

may cause interference.

2 . BASE UNIT A N T E N N A

1 . TELEPHONE LINE

CONNECTION JACK

Pg. 6, 7, 10, 12, 46

5 .P O W E R - I N

CONNECTION JACK

Pg. 6, 7

6 . TONE-PULSE SELECT

SWITCH Pg.7, 46

3 . RING SELECT S W I T C H

Pg. 37

4 . MESSAGE A L E RT S W I T C H

Pg. 37

8 .A N N O U N C E M E N T

O N LY / I N C O M I N G

MESSAGE SWITCH

7 . RINGER ON/OFF

S W I T C H