User Manual

Headset Feature

Your telephone can utilize a headset (not included) to be

connected to your HANDSET for you to enjoy hands-free

communication. Pull out the HEADSET JACK COVER, then

insert the small plug at the end of the headset into the

HEADSET JACK at the right side of the HANDSET. Follow the

procedures discussed in “Receiving Calls” and “Placing Calls”

to receive and place a call.

NOTE: When you plug the headset plug into the HEADSET

JACK it automatically mutes the MICROPHONE and

SPEAKER of the HANDSET. Unplug the headset to

return the HANDSET to normal use.

Headsets are available at most retail outlets that sell telephone

equipment. The HEADSET JACK is compatible with 2.5mm

headset plugs only.

Redial Feature

1. If you get a busy tone, press the button or

place the HANDSET on the BASE UNIT to hang up.

2. Later, press the button again.

3. Listen for a dial tone.

4. Press the button. This will automatically redial

the last telephone number you called in TALK mode.

5. When you have finished with your call, press the

button again (the BASE UNIT IN USE LED

indicator will turn off) or place the HANDSET on the

BASE UNIT.

NOTE:

If you are too far away from the BASE UNIT, the HANDSET emits “beep” sounds to warn you

that the background noise level is too high for proper communication between the HANDSET

and the BASE UNIT. When you hear this sound, you should move closer to the BASE UNIT to

reduce the noise level. Otherwise, the call will automatically cut off.

TALK

RE/PA

SAVE

TALK

Caller ID System Operation