Quick Start Guide
AirFinder Quick Start Guide
10
c. Power and Reset Conditions on Location Beacon
o LED Behavior when Location Beacon is powered
▪ No LEDs will light for approximately 15 seconds
▪ The LED labeled 'SL' will light solid for 60 seconds
▪ If an AF3 AP is detected, the SL LED will then blink at a roughly 2Hz rate
▪ Otherwise, the LED will turn off until an AP is detected
o Reset
▪ To reset the Location Beacon, either:
• Insert a paperclip into the hole marked 'reset'
• Cycle power to the device (e.g. by unplugging it, waiting for several
seconds, then plugging it back in)