User Manual

43
5.8 Temporary Factory Reset
Do not reset the server unless you forget admin password or cannot log into the server. Please note:
Your data will not be lost. No need to back up.
Steps:
●Power off and power on the server box. When you hear a long beep, use a paper clip to press the RST
button and hold until you hear another long beep.
●Wait for a moment. The READY light at the front panel of the server box will be out or flashing.
●When READY light becomes steady, the server is successfully set back to factory settings.
●Server network settings will be restored to factory set. IP address: 192.168.1.2 and subnet mask:
255.255.255.0.
●Admin password will be restored to: “admin”.
●Login the server with factory IP address (192.168.1.2), user name (admin) and password (admin).
Click “Server” and then “User Account” to change admin account and password. Click “Apply”. Or
“Network Settings” to change the server’s IP address.
●Power off the server and then power on to restart it. Please note: if you didn’t change IP address
during the reset, the IP address will be auto set back to the one before your reset. Login the server with
the IP you set and the new admin account and password.