User's Manual

LEARN
INTO
PANEL
[e-mail]
Qolsys Inc. proprietary.
Reproduction without permission is not permitted.
STEP
2
STEP
1
Press and hold
the arm and
disarm buttons
down for three
seconds to send
an emergency
panic signal to
the panel.
STEP
3
ARMING
YOUR
SYSTEM
DISARMING
YOUR
SYSTEM
STEP
4
SENDING A
PANIC
SIGNAL
Place your panel in
“autolearn" mode
Customize name and settings
as desired and and touch “ADD”
ADD
Press and hold arm and disarm
buttons to “tamper” the device
Press the disarm
button down
once until the red
LED lights up to
disarm the
system.
Press the arm
button down
once until the red
LED lights up for
stay mode.
Press a second
time to arm away.
Document#: IQDW-QG-1-17
Revision#: 1/4/17
Issue Date: JAN 2017
Qolsys Product #: QS1331-840
FCC ID: 2ABBZ-RF-KEYFOB
IC: 11817A-RFKEYFOB
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.
Cet appareil est conforme avec Industrie Canada exempts de licence standard RSS (s). Son fonctionnement est soumis aux deux conditions suivantes: (1) cet appareil ne doit pas provoquer d'interférences et (2) cet appareil doit accepter toute
interférence, y compris celles pouvant causer un mauvais fonctionnement de l'appareil.
CONTACT TECH SUPPORT
GOT QUESTIONS?