RATTLESNAKE WIRELESS FOLLOW FOCUS CONTROLLER MANUAL BOOK © 2017 Cine Gears INC. All Rights Reserved.
Statement of Conditions In the interest of improving internal design, operational function, and/or reliability, Cine Gears Inc. reserves the right to make changes to the products described in this document without notice. Cine Gears Inc. does not assume any liability that may occur due to the use or application of the product(s) or circuit layout(s) described herein. FCC Compliance Notice: Radio Frequency Notice The device has met the FCC 15.247 requirement.
Information to the user The user’s manual or instruction manual for an intentional or unintentional radiator shall caution the user that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Contents Introduction 2 Rattlesnake Follow Focus User Manual 3 Disclaimers 6 About Cinegears 8 © 2017 Cine Gears INC. All Rights Reserved.
Introduction The Cinegears Rattlesnake Controller is a wireless lens control kit for driving your lens rings (focus, iris, and zoom.) The Cinegears Rattlesnake Controller has been redesigned to be more ergonomic than ever before. With up to 20 hours of continuous shooting per battery charge, control your lens focus, iris, or zoom with precision from up to 200 meters away with our Cinegears Rattlesnake Controller.
User Manual Controller The controls have been designed for ease of use: They allow for preset memory points, where you can save up to four, as well as two lock points that will cause the controller to vibrate as you approach them. Choose from 16 different speed levels to control the transition speed of the presets, and 4 different damping levels from ultraresponsive to ultra smooth.
User Manual Manual Calibration Specifically used with infinity lenses that have no start or end point. Press (SET) + (B) for 3 seconds until you see the (A), (B), (C), (D) lights go on. Then use (C) or (D) button to control the lens. (Hold down the C or D key for more than 3 seconds to rotate continuously.) Once it rotates to the proper position, click the (A) button to set a starting point, (B) button to set the end point.
User Manual User Manual Remote Record Trigger Press (REC) on your controller to toggle Recording mode ON or OFF. Changing Damping Setting Press and hold (POWER) + (REC) + (A) to set motor to damping 1 (Responsive +). Press and hold (POWER) + (REC) + (B) to set motor to damping 2 (Responsive). Press and hold (POWER) + (REC) + (C) to set motor to damping 3 (Smooth). Press and hold (POWER) + (REC) + (D) to set motor to damping 4 (Smooth +).
Disclaimers FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Disclaimers Terms and Conditions Congratulations on purchasing your new CINEGEARS product. Please read this manual carefully before using the product. By using this product, you hereby agree to this disclaimer and signify that you have read it in full. You agree that you are responsible for your own conduct and any content created while using CINEGEARS products, and for any consequence thereof.
About Cine Gears Inc. Cine Gears Inc. is an industry leading company that designs and manufactures digital wireless follow focus systems, lens control systems, camera motion control systems and accessories for film and broadcast industry. As a big believer in the power of creativity and ideas, we designed the Pegasus cablecam, the wireless motor drive that integrated a built in wireless transmitter, and the wireless finger wheel controller. The Cine Gears Inc.