User Manual

User Manual
© 2017 Cine Gears INC. All Rights Reserved. 4
Manual Calibration
Specifically used with infinity lenses that have no start or end point. Press
(SET) + (B) for 3 seconds until you see the (A), (B), (C), (D) lights go on. Then use
(C) or (D) button to control the lens. (Hold down the C or D key for more
than 3 seconds to rotate continuously.) Once it rotates to the proper
position, click the (A) button to set a starting point, (B) button to set the end point.
After points are set, the (A), (B), (C), and (D) lights turn off to indicate the initialization
has been completed.
Recalibrating Your Controller
Rotate the focus ring clockwise to desired start point; hold (SET) + (REC) + (POWER)
buttons together for 3 seconds. Rotate to the desired end point and press (SET)+
(REC)+(POWER) for 3 seconds again.
Setting Up Vibration and Lock Points
To turn the vibration on or off, press and hold (REC) for 3 seconds.
Press and hold (REC) + (A) to set controller to “M-Normal.” Lock points can
only be set while controller is in “M-Normal” mode.
To set one lock point, turn controller to desired start point and press and hold
(SET) + (C) for 3 seconds.
To set a second lock point, turn the controller to the desired point and press
and hold (SET)+(D) for 3 seconds.
To set the controller to “M-Lock” mode, press and hold (REC)+(B) for 3
seconds. In “M-Lock” mode, controller cannot move past set lock points.
To set the controller to “M-Zoom” mode, press and hold (REC)+(C) for 3
seconds. In “M-Zoom” mode, controller cannot move past set lock points. In
“M-Zoom,” controller also moves more slowly between set lock points for
finer control.
To clear all lock points, press and hold (REC) + (D).