User Manual

1） Ensure the video source output of the camera is OK, and the HD monitor

is powered on and switched to connected video input port.

2） Ensure 2 TX antennas are installed. For optimal results set the dual

antennas in the form of a “V” and maintain unobstructed line of sight

between transmitter and receiver. Below gure for your reference.

VIDEO

LINK

3） Ensure all input, output SDI or HDMI cables are connected.

4） Ensure both transmitter and receiver are powered via battery or DC input.

Then turn on power switch of the transmitter and receiver respectively. The

POWER indicator will then light.

5） Ensure the transmitter and receiver is set with the same frequency.

6） If the camera is on and video input is OK, TX side VIDEO indicator will light.

Installation