User Manual

1) Ensure the video source output of the camera is OK, and the HD monitor is

powered on and switched to connected video input port.

2) Ensure 2 TX antennas are installed, preferably with an orthogonal angle to each

other for best RF performance, as in figure below.

3) Ensure all input, output SDI or HDMI cables are connected.

4) Ensure both the transmitter and receiver are powered via battery or DC

input. Then turn power switch of the transmitter and receiver, respectively, to

‘ON’. The ‘Power’ indicator will then light.

5) Ensure the frequency knobs of transmitter and receiver are set with the

same number, this will make sure the transmitter and receiver work with

same RF frequency.

6) If the camera is on and video input is OK, TX side 'video' indicator will light

7) Before RX finished wireless link with TX, 4 “RSSI” indicators and “Video”

indicators are off; when wireless link is OK, “RSSI” indicators will light first,

and “RSSI” will indicate the received RF signal strength. If the receiver

detects wireless video normal internally from air interface, “Video” indicator

will light. Before that, if SDI or HDMI video out port of the receiver has HD

monitor connected, it will display an OSD of “Link Connecting……” as in the

figure below.

150M Installation

Getting Started

150M Installation

Getting started

Transmitter

1) Ensure the video source output of the camera is OK, and the HD

monitor is powered on and switched to connected video input port.

2) Ensure 2 TX antennas are installed, preferably with an orthogonal

angle to each other for best RF performance, as in figure below.

3) Ensure all input, output SDI or HDMI cables are connected.

4) Ensure both the transmitter and receiver are powered via battery or

DC input. Then turn power switch of the transmitter and receiver,

respectively, to ‘ON’. The ‘Power’ indicator will then light.

5) Ensure the frequency knobs of transmitter and receiver are set with the

same number, this will make sure the transmitter and receiver work with

same RF frequency.

6) If the camera is on and video input is OK, TX side 'video' indicator will

light