User's Manual

© 2017 Cine Gears INC. All Rights Reserved. 2
Cautions
Warning
Electrical Considerations
Please read this user introduction manual to become familiar with the features of the
Ghost-Eye series products before operation. Failure to operate the product correctly
can result in disturbing other film equipment on set. This product is not intended for
use by children without direct adult supervision. Do not use with incompatible compo-
nents, or alter this product in any way outside of the documents provided by Cinege-
ars. These safety guidelines contain instructions for installation, operation, and mainte-
nance. It is essential to read and follow all of the instructions in the manual, and all the
notices and warnings regarding Ghost Eye series products prior to assembly, set up,
or use to prevent any damage or interference.
1. Do not use this product in extreme heat, cold, humidity, or environments with dust.
2. Do not drop the unit or cause impact against hard surfaces.
3. These products are not waterproof: do not expose the units to moisture.
4. Do not dismantle, assemble, or otherwise alter the products.
1. When this device is sharing a power supply or battery with other equipment, please
ensure all signal and power cables are well connected before turning on the Ghost Eye
units' power.
2. When this device is sharing a power supply or battery with other equipment, please
ensure the power switch is turned off before connecting or disconnecting any signal or
power cables from the Ghost Eye units.
3. When this device is sharing a power supply or battery with other equipment, please
check the polarity of the power connectors of all equipment to ensure the inside
conductor is positive. If the polarity of wer connectors of all equipment to ensure the
inside conductor is positive. If the polarity of the power connector is unknown, please
check the user manual to make sure the outer conductor of the SDI or HDMI connector
is connected to the negative of the power supply. Otherwise, the quipment will not be
able to share the same power supply with the Ghost Eye unit.