User Manual

User Manual

Transmitter

Fix the three antennas (5G x2, 2.4G x1) respectively.

Connect the SDI or HDMI video source to the “SDI IN”/”HDMI IN” of transmitter (when both SDI and

HDMI video are inputted, it will auto select the SDI video for transmission).

If needed, you can connect the SDI out (loop through) to other equipment as well.

Connect the DC power to the transmitter or use a F550/F970 battery on the battery plate.

Power on the transmitter.

Set the Channel (must set both transmitter and receiver to the same channel)

Receiver

Fix the six antennas (5Gx5, 2.4Gx1) respectively.

Connect the “SDI OUT”/”HDMI OUT” port of the receiver to the monitor or other device.

Connect DC power via power cable or use V-lock battery on the battery plate.

Power on the receiver.

Set the Channel (must set both transmitter and receiver to the same channel).

After 5-10s, the video transmission will be shown on the monitor.

Turning Fan On or Off

Hold the “+” and “-” buttons down on the transmitter.

Select “+” to toggle between fan motor speed and fan on/off controls.

Press “MENU” to select fan on/off controls.

Use “+” or “-” to turn fan on or off.

Press ”MENU” to confirm.