User`s manual

NexSens Technology, Inc.
iSIC User‟s Manual 25
With iChart running, open without a project, and select Advanced | Terminal. Select the COM
port the modem is connected to from the drop down menu, make sure the Connection is set to
Direct connect and click Connect. Note: do NOT check the „use iSIC‟ checkbox.
A white window will appear. To activate the modem:
1. Type „at‟ and make sure you see an „OK‟ displayed on the screen.
2. Next type AT*PROVISION=000000, 0123456789
3. After a few moments the modem should respond with: “Master Reset Succeeded”. With
any other response, contact Sprint to check the account status.
4. Cycle power to the modem by removing the two fuses on the iSIC data logger and
putting them back in.
Note: if you are not able to connect to the modem, test the connection with Wireless Ace 3G
software, available in the 3100-iSIC Sprint companion CD located on the web at:
http://www.nexsens.com/support/downloads.htm