SA505 Bluetooth® Wireless Stereo Headset First steps… 1 2 3 Charge your SA505 See CHARGING section Pair your SA505 to Bluetooth devices See PAIRING section.
OVERVIEW - SA505 HEADSET [1] USB Connector [2] Power On/Off [3] Red LED Charging Indicator [4] Microphone [5] Volume + [6] Volume [7] Play [8] Forward [9] Backward [10] Red/Blue LED Status Indicator Figure 1. Right Ear Piece Figure 2. Left Ear Piece with Microphone Retracted Figure 3. Left Ear Piece with Microphone Extended Figure 4. Wearing the Headset Bluetooth® is a registered trademark owned by Bluetooth SIG, Inc. U.S.A. and licensed to SouthWing.
COMMANDS SUMMARY TABLE How to? Action Headset Response Power On Power Off Volume up Move power switch to ON Move power switch to OFF In ON state, press Vol+ Button repeatedly Volume down Pairing Mode In ON state, press Vol- Button repeatedly In ON state press and hold Play Button for 5 sec and see the pairing instructions of your phone During incoming call, fully extend the microphone During incoming call press and hold Play Button for 1 sec During outgoing, call press and hold Play Button for 1 sec
Introduction Thank you for choosing an SA505 Bluetooth® Stereo Headset from Cingular, powered by SouthWing. This user guide provides all the information you will need to use and care for your product. All relevant information regarding your SouthWing product can be found on the support section of our website: www.south-wing.com/cingular-sa505 1. Charging the Headset You will need to charge the battery of your Headset. To do so, follow these steps: 1. Make sure the Headset is turned off. 2.
2. Press and hold the Play Button [7] for about 5 seconds until the Status Light [10] flashes blue and red alternately and 2 short tones are heard. 3. Then complete normal pairing process by following points 1 and 2 of the auto-pairing section above. Please Note: • Before pairing to a device, make sure the Headset is not connected to any device. • You may connect the Headset with an audio source and a mobile phone simultaneously.
Pause / Resume music** To pause music while playing, press the Play Button [7] one time. To resume, press the Play Button one time again. Music skip forward / backward** To skip forward and backward one track or go up or down in a play list, press the Forward Button [8] or Backward Button [9] one time. Connecting / Disconnecting from the music player** You may wish to disconnect the Headset from the stereo music device in order to reduce battery consumption.
If you wish to have all of your calls accepted automatically (without any button presses), you can enable the automatic call pick up mode. To activate this mode, press the Play Button [7] 5 times. When you receive an incoming call, your Headset will automatically answer the call. To deactivate this mode, simply press again the Play Button [7] 5 times. Please note: •The audio quality of your voice (as heard by the other party) will be improved by having the microphone fully extended during a call.
approved service technician. • If the product becomes dirty, it should be cleaned with a soft cloth. Do not use any cleaning agents as these may damage the plastics, electronics or battery. • Do not use this product while driving, may reduce your ability to react to road conditions. • As this product contains parts which may cause injury if swallowed, keep it out of reach of children.
The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly approved by the party responsible for compliance may void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
