Printer User Manual

Programming Reference
VERSAJET
Character height selection
Bit 2 Bit 1 Bit 0 Hex Decimal Height
Off Off Off 00 0
1(normal)
Off Off On 01 1
2(double-height)
Off On Off 02 2
3
Off On On 03 3
4
On Off Off 04 4
5
On Off On 05 5
6
On On Off 06 6
7
On On On 07 7
8
[Notes]
 The character size set by this command is effective for alphanumeric, Kana, multilingual
and user-defined characters.
 When the characters are enlarged with different heights on one line, all the characters on
the line are aligned at the baseline.
 When the characters are enlarged widthwise, the characters are enlarged to the right,
base on the left side of the character.
 ESC ! can also turn double-width and double-height modes on or off.
 In standard mode, the character is enlarged in the paper feed direction when
double-height mode is selected, and it is enlarged perpendicular to the paper feed
direction when double-width mode is selected. However, when character orientation
changes in 90° clockwise rotation mode, the relationship between double-height and
double-width is reversed.
83