User guide

FuzzyScan
Programming Manual
Configure Your FuzzyScan
76
[Data Replacer]
 Scan “Replacer Control” and set bar code symbology to
“48”.
 Scan “1st Replacement” and set the identified position to
“00”, then replaced character to “41” (Hex Code of A).
[Data Organizer]
 Scan “Organizer Control” and set bar code symbology to
“48”.
 Scan “1st Organization” and set the identified position to
“16”, then set the data transmission to “0” (forward).
 Scan “2nd Organization” and set the identified position to
“17”, then set the data transmission to “1” (backward).
 Scan “END” (Exit) to terminate the programming.
[Important Notice]
Please note that Condensed DataWizard will follow the
preset working flow as below:
Verifier 

 Formatter 

 Replacer 

 Organizer
So when you set the identified position in Data Organizer,
you must consider the inserted data which you already set
via Data Formatter.