Barcode Reader User Manual

FuzzyScan
Programming Manual
Configure Your FuzzyScan
47
PROGRAM
Condensed DataWizard
♦
♦♦
♦ Data Formatter Setting ♦
♦♦
♦
F_DEFAULT
Family Code Selection P.C Parameter Selection Option Code 2nd Option Code
Formatter Control
SS
MS
MS
Disable

Select one bar code symbology
Select all bar code symbologies
FIN
(2 digits)
00
automatic termination
automatic termination
1st Insertion
SS
DS
Disable

Enable
2-digits identified position; max. 3 insertion characters
FIN
(2 digits)
position
[1-3 characters], [FIN]
2nd Insertion
SS
DS
Disable

Enable
2-digits identified position; max. 3 insertion characters
FIN
(2 digits)
position
[1-3 characters], [FIN]
3rd Insertion
SS
DS
Disable

Enable
2-digits identified position; max. 3 insertion characters
FIN
(2 digits)
position
[1-3 characters], [FIN]
4th Insertion
SS
DS
Disable

Enable
2-digits identified position; max. 3 insertion characters
FIN
(2 digits)
position
[1-3 characters], [FIN]

The Data Formatter is used to edit the scanned raw data prior to transmitting the data to the host computers or terminals. It allows you to select desired bar code
symbologies for formatter control, and provides Multiple Position Insertion and Multiple Character Insertion (max three characters) in the identified position.

While the Data Formatter is enabled, it arranges only scanned data without Preamble, Postamble, STX, ETX, Data Length, Prefix/Suffix Symbology ID or Record Suffix.
All of the above programmable parameters perform the same function depending on your setting.

Regarding the “Bar Code Selection” and “Position Calculation” of data formatter, please refer to page 45 for details.

Please note that all “Character” input should be referred to the ASCII/HEX Table listed in Appendix to find matched HEX value.