User`s guide

(9) Scan “Pair Mode” barcode command. The imager gives 2 short
beeps, and imager LED gives red blinks.
Pair Mode Command
After scanning the “Pair Mode” barcode command, the imager
will enter into “Sleep State”, if the imager is not placed on the
cradle within 10 seconds. You can press the trigger switch to
revert it to pairing process. If you want to switch it back to
“Uninstall State”, please press and hold the trigger switch for 2
seconds.
(10) Place the imager on the cradle within 10 seconds. The pairing
process will be automatically starting as below:
Imager gives continuous short clicks and red blinks during
pairing process.
You will hear the special 4 beeps in ascending tone. Now the
pairing process is completed.
Finally, the imager LED gives green blinks at regular interval,
and the connection status LED of cradle becomes green.
Paired
On Cradle
Pairing OK
Pair Mode Command
(11) Take MBC6890 off the DB100 smart cradle. To select your
desired host interface by scanning one of the corresponding
quick set commands listed in next page.
If the host interface setting has been changed, you will hear a
special “Configuration OK” sound first. And the imager will give
another 4 beeps in ascending tone to indicate the radio link
built. After that, the imager LED will give green blinks at regular
intervals to indicate that the imager is in the radio-connected
state.
MBC6890 User’s Guide
10