User`s guide

(6) Scan the “SPP Master Mode” barcode command, the imager
gives 2 short beeps and imager LED gives red blinks.
SPP Master Mode
Quick Set Command
After scanning the “SPP Master Mode” barcode command, the
imager will enter “Sleep State”, if the radio link is not built within
1 minute. You can press the trigger switch to revert it to SPP
Master process. If you want to switch it back to “Uninstall State”,
please press and hold the trigger switch for 2 seconds.
(7) << Set the MAC Address of Remote Bluetooth Device >>
Scan a 12-character barcode to obtain the MAC address of the
remote Bluetooth host system. The imager gives one beep, then
the imager LED blinks short red light continuously during the
radio building process. If the PIN Code or Passkey is requested
for security connection, please enter “00000000”.
(8) The MBC6890 imager gives 4 beeps in ascending tone to
indicate the radio link built. After that, the imager LED gives
green blinks at regular interval to indicate that the imager is in
radio-connected state.
The installation procedures will vary depending on different
remote Bluetooth host systems, operating systems and
Bluetooth drivers. Please follow the respective procedures to
build the connection accordingly.
MBC6890 User’s Guide
16