User`s guide

Activate Batch Mode

You can activate batch mode to have MBC6890 stored scanned data

without building the connection with a remote host system.

To enable this function, please scan “Enter Batch Mode” quick set

command. When a bar code is saved successfully, a good read beep

sounds and the LED flashes green. When the memory buffer is full, the

MBC6890 will give a long beep and the LED flashes red.

Once you scan “Enter Batch Mode” quick set command, the

pre-connected radio link will be discontinued and the MBC6890

will enter batch mode.

You can trigger the data transmission by scanning “Exit Batch Mode”

quick set command. After that, the radio link will be rebuilt

automatically. You will hear 4 beeps in ascending tone to indicate the

radio link built. Following two short beeps, the MBC6890 gives

continuous short clicks and red blinks during the transmission process.

After data transmission is completed, the imager indicates four short

beeps.

MBC6890 User’s Guide

Enter Batch Mode

Quick Set Command

Exit Batch Mode

Quick Set Command