User manual

Getting Started

(2) You can find a media width adjustment spacer inserted in

the media compartment groove. Push the spacer forward

and pull it out. Adjust the width adjustment spacer to fit one

of the grooves in accordance with the width of the label roll.

Grooves are available for the width from 34 to 58 mm with 3

mm per pitch.

MP3200 User’s Guide

Make Sure the Direction

of the Label Roll is Correct

(3) Set the label roll as shown in the following diagram.

(4) If you choose label printing by using the peeler function, the

backing material will be peeled away from the label as it is

printed. Tear the first label partially apart and thread the

label edge into the slot beneath the feed roller, keep the

backing material separated on the other side of the feed

roller. Then, close the media compartment cover. Press the

FEED button, the MP3200(BT) will forward the first label and

remain ready in the next printing position.

Insert the Spacer

Directioin the Correct

If you would like to use the peeler function, you have to

conduct length measurement firstly. Please refer to

“Conduct Length Measurement” before loading the

label roll.

Media Width

djustment Space

Feed Roller

Close the Cover