Specifications
Table Of Contents
- Contents
- Tables
- Figures
- 1 Introduction
- 2 Interface Characteristics
- 2.1 Application Interface
- 2.1.1 Pad Assignment
- 2.1.2 Signal Properties
- 2.1.3 USB Interface
- 2.1.4 Serial Interface ASC0
- 2.1.5 Serial Interface ASC1
- 2.1.6 Inter-Integrated Circuit Interface
- 2.1.7 UICC/SIM/USIM Interface
- 2.1.8 Enhanced ESD Protection for SIM Interfaces
- 2.1.9 Digital Audio Interface
- 2.1.10 Analog-to-Digital Converter (ADC)
- 2.1.11 RTC Backup
- 2.1.12 GPIO Interface
- 2.1.13 Control Signals
- 2.1.14 JTAG Interface
- 2.1.15 eMMC Interface
- 2.2 GSM/UMTS/LTE Antenna Interface
- 2.3 GNSS Antenna Interface
- 2.4 Sample Application
- 2.1 Application Interface
- 3 GNSS Interface
- 4 Operating Characteristics
- 5 Mechanical Dimensions and Mounting
- 6 Regulatory and Type Approval Information
- 7 Document Information
- 8 Appendix
Cinterion
®
ALAS5V Hardware Interface Description
5.3 Packaging
107
ALAS5V_HID_v00.030a 2019-03-20
Confidential / Preliminary
Page 105 of 124
5.3 Packaging
5.3.1 Trays
ALAS5V is shipped in 6x3 trays as illustrated in Figure 45.
The figure also shows the proper module orientation in the trays: The small round hole marking
pad A1 is furthest away from the beveled corner of the tray.
Figure 45: Shipping tray dimensions
5.3.2 Shipping Materials
The shipping trays are normally stacked as units of 10 trays plus one extra as a cover, and se-
cured with packaging tape. All trays have the beveled corner aligned in the same orientation.
A stacking unit (10 x 18 modules = 180 modules) together with a foam protection makes up the
content of a moisture barrier bag (MBB).
5.3.2.1 Moisture Barrier Bag
The foam protected stacking units are stored inside of a MBB, together with a humidity indicator
card and desiccant pouches. The bag is ESD protected and delimits moisture transmission. It
is vacuum-sealed and should be handled carefully to avoid puncturing or tearing. The bag pro-
tects the ALAS5V modules from moisture exposure. It should not be opened until the devices
are ready to be soldered onto the application.
The label shown in Figure 46 summarizes requirements regarding moisture sensitivity, includ-
ing shelf life and baking requirements. It is attached to the outside of the moisture barrier bag.