Specifications
Table Of Contents
- Contents
- Tables
- Figures
- 1 Introduction
- 2 Interface Characteristics
- 2.1 Application Interface
- 2.1.1 Pad Assignment
- 2.1.2 Signal Properties
- 2.1.3 USB Interface
- 2.1.4 Serial Interface ASC0
- 2.1.5 Serial Interface ASC1
- 2.1.6 Inter-Integrated Circuit Interface
- 2.1.7 UICC/SIM/USIM Interface
- 2.1.8 Enhanced ESD Protection for SIM Interfaces
- 2.1.9 Digital Audio Interface
- 2.1.10 Analog-to-Digital Converter (ADC)
- 2.1.11 RTC Backup
- 2.1.12 GPIO Interface
- 2.1.13 Control Signals
- 2.1.14 JTAG Interface
- 2.1.15 eMMC Interface
- 2.2 GSM/UMTS/LTE Antenna Interface
- 2.3 GNSS Antenna Interface
- 2.4 Sample Application
- 2.1 Application Interface
- 3 GNSS Interface
- 4 Operating Characteristics
- 5 Mechanical Dimensions and Mounting
- 6 Regulatory and Type Approval Information
- 7 Document Information
- 8 Appendix
Cinterion
®
ALAS5V Hardware Interface Description
7.1 Revision History
121
ALAS5V_HID_v00.030a 2019-03-20
Confidential / Preliminary
Page 117 of 124
Preceding document: "Cinterion
®
ALAS5V Hardware Interface Description" v00.014
New document: "Cinterion
®
ALAS5V Hardware Interface Description" v00.018
Preceding document: "Cinterion
®
ALAS5V Hardware Interface Description" v00.012
New document: "Cinterion
®
ALAS5V Hardware Interface Description" v00.014
Preceding document: "Cinterion
®
ALAS5V Hardware Interface Description" v00.006
New document: "Cinterion
®
ALAS5V Hardware Interface Description" v00.012
New document: "Cinterion
®
ALAS5V Hardware Interface Description" v00.006
Chapter What is new
Throughout
document
Added ASC2 (RXD2/TXD2 lines) serial interface as debug interface including test point
recommendation.
Removed support for LTE-TDD Band 41 (for ALAS5V-W).
Removed support for second I
2
C interface (I2CDAT2, I2CCLK2).
2.1.2 Revised test point requirements/recommendations for various interface lines.
2.1.7 Revised connecting circuit for voltage suppressor shown in Figure 11.
4.2.3.1 Added notes to Figure 29.
Chapter What is new
1.2.1 Revised Table 1 listing supported frequency bands, and added note regarding Bd41.
1.2.2 New section Supported CA Configurations.
4.2.1 Clarified remark on startup timing.
4.2.2 Added signal states after startup, and revised timings.
5.2.4.1 Added air temperature as storage condition.
6.3 Set section to TBD.
8.1 Updated ordering information.
Chapter What is new
Throughout
document
Removed mention of RING0 as line with possible remote wakeup functionality.
2.1.2 Added accuracy for ADCx_IN lines.
3 Revised information about the Dead Reckoning Sync Line.
4.2.3.5 New section Overall Shutdown Sequence.
4.2.4.1 Revised description of undertemperature shutdown URC.
Chapter What is new
-- Initial document setup.