Specifications

Cinterion
®
EXS82-W Hardware Interface Overview
5.4 Compliance with FCC and ISED Rules and Regulations
36
 EXS82-W_HIO_v00.038 2019-12-27
Public / Preliminary
Page 35 of 44
5.4 Compliance with FCC and ISED Rules and Regulations
The Equipment Authorization Certification for the Gemalto M2M reference application de-
scribed in Section 5.3 will be registered under the following identifier:
FCC Identifier: QIPEXS82-W
ISED Certification Number: 7830A-EXS82W
Granted to Gemalto M2M GmbH
Manufacturers of mobile or fixed devices incorporating EXS82-W modules are authorized to
use the FCC Grants and ISED Certificates of the EXS82-W modules for their own final products
according to the conditions referenced in these documents. In this case, an FCC/ IC label of
the module shall be visible from the outside, or the host device shall bear a second label stating
"Contains FCC ID: QIPEXS82-W"and “Contains IC: 7830A-EXS82W“. The integration is limited
to fixed or mobile categorized host devices, where a separation distance between the antenna
and any person of min. 20cm can be assured during normal operating conditions. For mobile
and fixed operation configurations the antenna gain, including cable loss, must not exceed the
limits TBD. dBi (850MHz) and TBD. dBi (1900MHz).
IMPORTANT:
Manufacturers of portable applications incorporating EXS82-W modules are required to have
their final product certified and apply for their own FCC Grant and ISED Certificate related to
the specific portable mobile. This is mandatory to meet the SAR requirements for portable mo-
biles (see Section 5.2 for detail).
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules and with ISED license-exempt RSS standard(s).
These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or televi-
sion reception, which can be determined by turning the equipment off and on, the user is en-
couraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
This Class B digital apparatus complies with Canadian ICES-003.
If Canadian approval is requested for devices incorporating EXS82-W modules the below
notes will have to be provided in the English and French language in the final user documen-
tation. Manufacturers/OEM Integrators must ens
ure that the final user documentation does
not contain any information on how to install or remove the module from the final product.
The module (Global LTE Cat.M1/LTE Cat.NB2/2G Data-Only Module & Global LTE Cat.M1/
LTE Cat.NB2 Data-Only Module) is limited to OEM installation only.