Specifications
Table Of Contents
- Contents
- Tables
- Figures
- 1 Introduction
- 2 Interface Characteristics
- 2.1 Application Interface
- 2.2 RF Antenna Interface
- 2.3 GNSS Interface
- 2.4 Sample Application
- 3 Operating Characteristics
- 3.1 Operating Modes
- 3.2 Power Up/Power Down Scenarios
- 3.3 Power Saving
- 3.4 Power Supply
- 3.5 Operating Temperatures
- 3.6 Electrostatic Discharge
- 3.7 Blocking against RF on Interface Lines
- 3.8 Reliability Characteristics
- 4 Mechanical Dimensions, Mounting and Packaging
- 5 Regulatory and Type Approval Information
- 6 Document Information
- 7 Appendix
Cinterion
®
EXS62-W/EXS82-W Hardware Interface Description
2.1 Application Interface
61
t EXS62-W_EXS82-W_HID_v01.200ee 2022-09-07
Public/ Released
Page 35 of 144
If using a SIM switch to change between usage of an external SIM and an eUICC as shown in
Figure 13, the module needs to be prepared for this dual mode by AT command.
By default, dual mode is disabled, and usage of the first SIM slot, i.e., the external SIM inter-
face, is configured - as shown by the following AT command result:
To configure and use the eUICC, dual mode has to be enabled, and usage of the second SIM
slot, i.e., the eUICC, needs to be specified - as shown by the following AT command sequence:
For details on these AT commands please refer to [1].
Figure 14 shows a direct connection of the internal eUICC to the module’s SIM interface lines.
In this case no dual mode is possible
Figure 14: eUICC interface without SIM switch
AT^SCFG?
…
^SCFG: "SIM/CS","0"
^SCFG: "SIM/DualMode","0"
…
OK
AT^SCFG="SIM/DualMode","1"
^SCFG: "SIM/DualMode","1"
OK
at^scfg="SIM/CS","3"
^SCFG: "SIM/CS","3"
OK
eUICC
Module
Baseband
controller
VSIM
CCIO
CCRST
CCCLK
CCIO pull up resistor and
VSIM capacitor 2.2µF Are mounted on the module
CC2_VPP
CC2_VCC
CC2_IO
CC2_RST
CC2_CLK
CCIN