Product Info
Table Of Contents
- Contents
- Tables
- Figures
- 1 Introduction
- 2 Interface Characteristics
- 2.1 Application Interface
- 2.2 RF Antenna Interface
- 2.3 GNSS Interface
- 2.4 Sample Application
- 3 Operating Characteristics
- 3.1 Operating Modes
- 3.2 Power Up/Power Down Scenarios
- 3.3 Power Saving
- 3.4 Power Supply
- 3.5 Operating Temperatures
- 3.6 Electrostatic Discharge
- 3.7 Blocking against RF on Interface Lines
- 3.8 Reliability Characteristics
- 4 Mechanical Dimensions, Mounting and Packaging
- 5 Regulatory and Type Approval Information
- 6 Document Information
- 7 Appendix
Cinterion
®
TX62-W(-B/-C)/TX82-W Hardware Interface Description
4.3 Mounting TX62/TX82 onto the Application Platform
130
t TX62-W_TX62-W-x_TX82-W_HID_v01.000 2021-05-19
Confidential / Preliminary
Page 119 of 154
4.3.3.2 Maximum Temperature and Duration
The following limits are recommended for the SMT board-level soldering process to attach the
module:
• A maximum module temperature of 240°C. This specifies the temperature as measured at
the module’s top side.
• A maximum duration of 15 seconds at this temperature.
Please note that while the solder paste manufacturers' recommendations for best temperature
and duration for solder reflow should generally be followed, the limits listed above must not be
exceeded.
TX62/TX82 is specified for one soldering cycle only. Once TX62/TX82 is removed from the ap-
plication, the module will very likely be destroyed and cannot be soldered onto another appli-
cation.