Product Info
Table Of Contents
- Contents
- Tables
- Figures
- 1 Introduction
- 2 Interface Characteristics
- 2.1 Application Interface
- 2.2 RF Antenna Interface
- 2.3 GNSS Interface
- 2.4 Sample Application
- 3 Operating Characteristics
- 3.1 Operating Modes
- 3.2 Power Up/Power Down Scenarios
- 3.3 Power Saving
- 3.4 Power Supply
- 3.5 Operating Temperatures
- 3.6 Electrostatic Discharge
- 3.7 Blocking against RF on Interface Lines
- 3.8 Reliability Characteristics
- 4 Mechanical Dimensions, Mounting and Packaging
- 5 Regulatory and Type Approval Information
- 6 Document Information
- 7 Appendix
Cinterion
®
TX62-W(-B/-C)/TX82-W Hardware Interface Description
4.3 Mounting TX62/TX82 onto the Application Platform
130
t TX62-W_TX62-W-x_TX82-W_HID_v01.000 2021-05-19
Confidential / Preliminary
Page 121 of 154
4.3.4.2 Processing Life
TX62/TX82 must be soldered to an application within 72 hours after opening the moisture bar-
rier bag (MBB) it was stored in.
As specified in the IPC/JEDEC J-STD-033 Standard, the manufacturing site processing the
modules should have ambient temperatures below 30°C and a relative humidity below 60%.
4.3.4.3 Baking
Baking conditions are specified on the moisture sensitivity label attached to each MBB (see
Figure 67 for details):
• It is not necessary to bake TX62/TX82, if the conditions specified in Section 4.3.4.1 and
Section 4.3.4.2 were not exceeded.
• It is necessary to bake TX62/TX82, if any condition specified in Section 4.3.4.1 and Section
4.3.4.2 was exceeded.
If baking is necessary, the modules must be put into trays that can be baked to at least 125°C.
Devices should not be baked in tape and reel carriers at any temperature.
4.3.4.4 Electrostatic Discharge
Electrostatic discharge (ESD) may lead to irreversible damage for the module. It is therefore
advisable to develop measures and methods to counter ESD and to use these to control the
electrostatic environment at manufacturing sites.
Please refer to Section 3.6 for further information on electrostatic discharge.