Specifications
Table Of Contents
- Contents
- Tables
- Figures
- 1 Introduction
- 2 Interface Characteristics
- 2.1 Application Interface
- 2.2 RF Antenna Interface
- 2.3 GNSS Interface
- 2.4 Sample Application
- 3 Operating Characteristics
- 3.1 Operating Modes
- 3.2 Power Up/Power Down Scenarios
- 3.3 Power Saving
- 3.4 Power Supply
- 3.5 Operating Temperatures
- 3.6 Electrostatic Discharge
- 3.7 Blocking against RF on Interface Lines
- 3.8 Reliability Characteristics
- 4 Mechanical Dimensions, Mounting and Packaging
- 4.1 Mechanical Dimensions of TX62-W
- 4.2 Mechanical Dimensions of TX82-W, TX82-W-B, TX62-W-B and TX62-W-C
- 4.3 Mounting TX62/TX82 onto the Application Platform
- 4.4 Packaging
- 5 Regulatory and Type Approval Information
- 6 Document Information
- 7 Appendix
Cinterion
®
TX62-W/TX82-W Hardware Interface Description
3.3 Power Saving
120
t TX62-W_TX62-W-x_TX82-W-x_HID_v01.200d 2022-09-08
Public / Preliminary
Page 90 of 170
3.3.1 Low Power Modes
There are two specific low power modes available that can be configured to allow TX62/TX82
to save power - SLEEP mode (Section 3.3.1.1) and SUSPEND mode (Section 3.3.1.2).
Figure 41 illustrates how the module transits between its operating modes including SLEEP
and SUSPEND modes.
Figure 41: Low power modes with state transitions
Notes:
• When all serial interfaces (i.e. ASC0, and ASC1) are idle, the module can enter SLEEP or
SUSPEND mode depending on additional configuration settings.
• The serial interfaces are not idle if there is any response message not read out from any of
them.
Idling
(IDLE)
Data transfer
SUSPENDSLEEP
POWER DOWN
AT^SMSO ON signal
ON signal
RING0 toggle
(+URC and/or data)
RTS0 assertion
(+URC and data)
Serial I/f inactive
(+AT^SCFG „MeOpMode/
PowerMgmt/Suspend“ enabled,
required: AT+CPSMS/AT+CEDRXS)
Serial i/f inactive
(+AT^SCFG „MeOpMode/
PwrSave“ enabled, optional:
AT+CPSMS/AT+CEDRXS)
No data available
RRC release
Data available
Serial i/f active