Specifications

Cinterion
®
TX62-W/TX82-W Hardware Interface Description
3.4 Power Supply
120
t TX62-W_TX62-W-x_TX82-W-x_HID_v01.200d 2022-09-08
Public / Preliminary
Page 103 of 170
I
BATT+
1
(i.e., only
BATT+
BB
)
Peak Current @ RRC
connected Active Trans-
mission
3
VBATT = 2.55V (TX62-
W)
VBATT = 2.8V (TX82-W)
Band1, 20dBm 572 - - 528 - mA
Band2, 20dBm 556 - - 516 - mA
Band3, 20dBm 564 - - 492 - mA
Band4, 20dBm 528 - - 500 - mA
Band5, 20dBm 576 - - 608 - mA
Band8, 20dBm 656 - - 556 - mA
Band12, 20dBm 548 - - 476 - mA
Band13, 20dBm 604 - - 592 - mA
Band18, 20dBm 624 - - 596 - mA
Band19, 20dBm 632 - - 588 - mA
Band20, 20dBm 636 - - 580 - mA
Band25, 20dBm 556 - - 516 - mA
Band26, 20dBm 604 - - 560 - mA
Band27, 20dBm 640 - - 596 - mA
Band28, 20dBm 588 - - 508 - mA
Band66, 20dBm 520 - - 496 - mA
Band85, 20dBm 556 - - 496 - mA
Average idle supply cur-
rent
(GNSS on)
CAT-M1 active (UART
active) @ DRX=128
GNSS NMEA output off
65 66 65 64 TBD. mA
GPRS active (UART active)
@ DRX=128
GNSS NMEA output on
64 66 65 64 TBD. mA
1. With an impedance of Z
LOAD
=50Ω at the antenna connector, Measured at 25°C at 3.8V.
2. Measurements start 6 minutes after switching ON the module,
Averaging times:
SUSPEND mode: 3 minutes (T3324 = 3s, T3412 = 14400s)
SLEEP mode: 10 minutes, (PSM disabled, eDRX disabled)
Idle eDRX mode: 30 minutes, (PSM disabled, eDRX enabled)
Connected DRX mode: 10 minutes,
RRC connected modes: 3 minutes,
Communication tester settings: no neighbor cells, no cell re-selection etc, RMC (reference measurement channel), SUSPEND/
SLEEP (with PSM/eDRX) is enabled via AT command
3. Communication tester settings:
RMC mode, Half Duplex,
Cat M1 Channel Bandwidth: 10MHz
Modulation: QPSK.
RB setting: 1 UL RBs, 4 DL RBs
4. TX62-W-C supports the following LTE Cat M1 bands only: Band 1, 3, 8, 20, 28, 31, 72
Table 25: Current consumption ratings Cat M1 (TX62/TX82)
Description Conditions Typical rating Unit
TX62-W TX62-W-B TX62-W-C TX82-W TX82-W-B