User's Manual

Cipherium bonalinx-W 1300
Administrator’ s Manual
8
3. Installation
3.1. Installing the bonalinx-W 1300
3.1.1. System Requirements
y Standard 10/100BaseT including four network cables with RJ-45 connectors.
y All PCs need to install the TCP/IP network protocol.
3.1.2. Installation Procedure
Following the following steps to install the bonalinx-W 1300:
1. Make sure the power of the bonalinx-W 1300 is turned off.
2. Connect the WAN port.
Use the network cable of the 10/100BaseT to connect to the bonalinx-W 1300 and the network
not managed by the bonalinx-W 1300 system such as the ATU-Router of ADSL, port of Cable
Modem, or the Switch or Hub on the LAN of a company.
3. Connect the port. (Optional)
Use the network cable of the 10/100BaseT to connect to the bonalinx-W 1300 and the network
not managed by the bonalinx-W 1300 system such as the ATU-Router of ADSL, port of Cable
Modem, or the Switch or Hub on the LAN of a company.
4. Connect the Public LAN.
The Public LAN is used to connect the desired network for management or WLAN, and all
users connected to the Public LAN must login successfully before using the network resources.
Use the network cable of the 10/100BaseT to connect to the Switch or Hub of the Public LAN,
and then use the network cable of the 10/100BaseT to connect to the Administrator’s PC. If
it is necessary to connect the PC or wireless AP directly to the Public LAN, then we need to