User's Manual

Cipherium bonalinx-W 1300

Administrator’ s Manual

use the cross over line.

Warning: Public LAN cannot connect to Layer 3 device.

5. Connect the Private LAN port.

The Private LAN port is used to connect the trustful network or Ethernet. In other words, the

computer connected to the bonalinx-W 1300 from Private LAN does not require login to use

the network resources. This port can be used to connect to a server such as File Server or a

DataBase Server, etc. Use the network cable of the 10/100BaseT to connect to the Switch or

Hub of the Private LAN, and then use the network cable of the 10/100BaseT to connect to the

Administrator’s PC. If it is necessary to connect the PC or wireless AP directly to the Private

LAN, then we need to use the cross over line.

6. Turn on the power.

Plug the bundled power supply connector into the socket.

7. Check the LED indicating light.

After the power is on, the power indicating light should be lit. The WAN and indicating lights

should be lit when the WAN and ports are properly connected to the network equipment. The

corresponding indicating lights also should be lit when the Public LAN and Private LAN ports

are properly connected.

3.1.3. Setting the PC for the Public LAN and Private LAN

Sections

After the bonalinx-W 1300 is installed, the following must be set up for the Public LAN and

Private LAN sections:

y TCP/IP Network Setup

y Internet Connection Setup