User's Manual

AirLive WIAS-1200G
User’s Guide
27
4.1.4 LAN1 & LAN2 Configuration
User authentication for the two LAN ports can be enabled or disabled.
y LAN1 & LAN2 Port
IP PNP: Users can use any IP address to connect to the system. Regardless of what the IP address at the user
end is, users can still be authenticated through AirLive WIAS-1200G and access the network.
User Authentication: Choose to enable or disable this function. If “User Authentication” is disabled, users
can access Internet without being authenticated.
Operation Mode: Choose one of the two modes, NAT mode and Router mode, by the requirements.
IP Address: Enter the desired IP address for the LAN1 & LAN2 port.
Subnet Mask: Enter the desired subnet mask for the LAN1 & LAN2 port.
y DHCP Server Configuration
There are three methods to set the DHCP server: Disable DHCP Server, Enable DHCP Server and Enable
DHCP Relay.
1. Disable DHCP Server: Disable DHCP Server function.
2. Enable DHCP Server: Choose “Enable DHCP Sever” function and set the appropriate configuration for
the DHCP server. The fields with red asterisks are required to be filled in.