User Manual
Table Of Contents
- Restore Default Settings
- Exit Setup without Changes
- Set Connection
- RF Auto Shutdown Duration
- Memory Mode Parameters
- List Setting
- Buzzer Settings
- Reading Redundancy Setting
- Scan Mode Setting
- Auto-Sense Setting
- Scanner Time-out Duration
- Negative Barcode Setting
- Delay between Reread
- Keyboard Wedge Parameters
- Laptop Support
- RS-232 Parameters
- Bluetooth Serial Port Parameters
- Prefix / Postfix Settings
- Character Substitution
- Code ID Selection
- Code ID Setting
- Length Code Setting (2 digits)
- Code 39 Length Code
- Italy Pharmacode Length Code
- French Pharmacode Length Code
- Industrial 25 Length Code
- Interleave 25 Length Code
- Matrix 25 Length Code
- Codabar Length Code
- UPCA Length Code
- UPCE Length Code
- EAN8 Length Code
- EAN13 Length Code
- Code 93 Length Code
- Code 128 Length Code
- EAN128/RSS Length Code
- MSI Length Code
- Plessey Length Code
- Telepen Length Code
- Select Readable Codes
- Code39 Parameters
- Italy Pharmacode Parameters
- French Pharmacode Parameters
- Industrial 25 Parameters
- Interleave 25 Parameters
Restore Default Settings Memory Mode Parameters
• Memory Mode
Enable
< Disable >
Exit Setup without Changes
• Clear Data
Clear
Confirm
Set Connection
*
Programming Instructions : (1) Read the label. (2) Read the Serial Number barcode
on the bottom of the desired 3660 Base Station within 5 seconds to complete this
setting.
• Send Data
• Memory Data Delay
RF Auto Shutdown Duration
< 0 >
2 sec
250 ms
3 sec
500 ms
5 sec
1 sec
8 sec
*
Programming Instructions : (1) Read the label. (2) Program the desired auto
shutdown duration (in minutes) by reading Decimal Digits on page 49. (3) Read the
“Validate” label (also on page 49) to complete this setting.
2
Enter Setup
1
Update