User Manual
Table Of Contents
- Restore Default Settings
- Exit Setup without Changes
- Set Connection
- RF Auto Shutdown Duration
- Memory Mode Parameters
- List Setting
- Buzzer Settings
- Reading Redundancy Setting
- Scan Mode Setting
- Auto-Sense Setting
- Scanner Time-out Duration
- Negative Barcode Setting
- Delay between Reread
- Keyboard Wedge Parameters
- Laptop Support
- RS-232 Parameters
- Bluetooth Serial Port Parameters
- Prefix / Postfix Settings
- Character Substitution
- Code ID Selection
- Code ID Setting
- Length Code Setting (2 digits)
- Code 39 Length Code
- Italy Pharmacode Length Code
- French Pharmacode Length Code
- Industrial 25 Length Code
- Interleave 25 Length Code
- Matrix 25 Length Code
- Codabar Length Code
- UPCA Length Code
- UPCE Length Code
- EAN8 Length Code
- EAN13 Length Code
- Code 93 Length Code
- Code 128 Length Code
- EAN128/RSS Length Code
- MSI Length Code
- Plessey Length Code
- Telepen Length Code
- Select Readable Codes
- Code39 Parameters
- Italy Pharmacode Parameters
- French Pharmacode Parameters
- Industrial 25 Parameters
- Interleave 25 Parameters
• Keyboard Alphabets Layout • Alphabet Transmission
< Default Layout >
AZERTY
QWERTZ
< Case Sensitive >
Ignore Case
• Digits Transmission
< Alphanumeric Key >
Numeric Key
• Keyboard Digits Layout
< Default Layout >
Lower Row
Upper Row
• Alt Composing
Yes
< No >
• Keyboard Capital Lock Type
< Default >
Shift Lock
Capital Lock
• Inter-Character Delay
*
Programming Instructions : (1) Read the label. (2) Program the desired inter-
character delay by reading Decimal Digits on page 49. (3) Read the “Validate”
label (also on page 49) to complete this setting.
• Capital Lock Setting
Capital Lock ON
< Capital Lock OFF >
Auto Detection
Laptop Support
< Disable>
Enable
8
Enter Setup
7
Update