User Manual
Table Of Contents
- Restore Default Settings
- Exit Setup without Changes
- Set Connection
- RF Auto Shutdown Duration
- Memory Mode Parameters
- List Setting
- Buzzer Settings
- Reading Redundancy Setting
- Scan Mode Setting
- Auto-Sense Setting
- Scanner Time-out Duration
- Negative Barcode Setting
- Delay between Reread
- Keyboard Wedge Parameters
- Laptop Support
- RS-232 Parameters
- Bluetooth Serial Port Parameters
- Prefix / Postfix Settings
- Character Substitution
- Code ID Selection
- Code ID Setting
- Length Code Setting (2 digits)
- Code 39 Length Code
- Italy Pharmacode Length Code
- French Pharmacode Length Code
- Industrial 25 Length Code
- Interleave 25 Length Code
- Matrix 25 Length Code
- Codabar Length Code
- UPCA Length Code
- UPCE Length Code
- EAN8 Length Code
- EAN13 Length Code
- Code 93 Length Code
- Code 128 Length Code
- EAN128/RSS Length Code
- MSI Length Code
- Plessey Length Code
- Telepen Length Code
- Select Readable Codes
- Code39 Parameters
- Italy Pharmacode Parameters
- French Pharmacode Parameters
- Industrial 25 Parameters
- Interleave 25 Parameters
RS-232 Parameters
• Flow Control
< None >
Scanner Ready
Data Ready
INV. Data Ready
• Activate RS232 Interface
• Baud Rate
115200
38400
19200
< 9600 >
4800
2400
1200
300
• Inter-Character Delay
*
Programming Instructions : (1) Read the label. (2) Program the desired inter-
character delay by reading Decimal Digits on page 49. (3) Read the “Validate”
label (also on page 49) to complete this setting.
• Parity
Even
Odd
< No Parity >
• Data Bit
< 8 >
7
10
Enter Setup
9
Update