User guide

147

Update

Chapter 4

Definin

Output Format

4.6.2 ACTIVATE THE CONCATENATION OF BARCODES

By default, the output sequence editing of the concatenation of barcodes is not applied.

When “Enforce Output Sequence” is enabled, all barcodes read by the scanner must meet

with the criteria for the concatenation. If data is found excluded from all output sequence

sets (= not meeting with the criteria), the scanner will not accept the reading, and

therefore, data will not be transmitted.

When “Apply Output Sequence” is enabled, only barcodes found meeting with the criteria

are counted for the concatenation. Those found not meeting with the criteria are

processed normally and individually.

Note: When it requires reading more barcodes to complete the “output sequence”

requirements, the scanner will respond with one short beep (low tone). After

reading an acceptable barcode, its LED indicator will become solid green and go off

quickly (= Good Read).

Upon completion of reading acceptable barcodes, the scanner will respond with

one short beep (high tone) and its LED indicator will become solid green and go off

quickly (= Good Read).

*Ignore Output

Sequence

Enforce Output

Sequence

Apply Output

Sequence

Warning: When disable the Multi-Barcode Editor later, the scan mode remains

unchanged. If Laser mode is not desired, proceed to select a scan mode

best suits the application.