User guide

71
The tables below list reader settings as well as symbology settings for the 2D scan
engine.
READER SETTINGS TABLE
2D Engine Description Default
Scan Mode Laser mode
Continuous Mode Non-stop scanning
 To decode the same barcode repeatedly, move away the scan beam
and target it at the barcode for each scanning.
Test Mode Non-stop scanning
 Capable of decoding the same barcode repeatedly
Alternate Mode Press the scan trigger to start with scanning.
 The scanning won't stop until you press the trigger again.
Aiming Mode Press the scan trigger to aim at a barcode. Within one second, press the
trigger again to decode the barcode.
 The scanning won't stop until (a) a barcode is decoded, (b) the pre-set
timeout expires, or (c) you release the trigger.
Laser Mode Hold down the scan trigger to start with scanning.
 The scanning won't stop until (a) a barcode is read, (b) the preset
timeout expires, or (c) you release the trigger.
Auto Off Mode Press the scan trigger to start with scanning.
 The scanning won't stop until (a) a barcode is read or (b) the preset
timeout expires.
Focus Mode Select the focus mode to control the working range:
 Far Focus – optimized to read at its far position
 Near Focus – optimized to read at its near position
 Smart Focus – toggles the focus position after every
frame
Far Focus
Decode Illumination Decide whether to flash illumination on every barcode
capture to aid decoding.
 Turn On (Internal LED)
 Turn Off
On
Aiming Pattern Decide whether to project the aiming pattern during
barcode capture.
 Turn On
 Turn Off
On
Appendix IV
2D SCAN ENGINE