Specifications

209

Update

Appendix II

Host Serial Commands

3610 SETUP BARCODES & SERIAL COMMANDS

Normally, you can configure the 3610 dongle by having a connected scanner read

3610-related setup barcodes.

1) Connect 3610 to the USB port of PC. You may need to install its driver first!

2) Refer to

3.1.1 Connect to 3610 for the target scanner to connect to 3610.

Read the “Set Connection” label first, and then the “Serial Number” label. Both labels

can be located at the back of 3610.

3) Read the following barcodes in sequence to configure 3610.

Enter Setup

Update

For 3610-related setup barcodes, refer to the Serial Command table below. Note that

for the “Version” and “GetID” barcodes, you must run HyperTerminal.exe or any text

editor to receive the information.

 If the output interface is USB Virtual COM, run HyperTerminal.exe on your

computer to receive the information.

 If the output interface is USB HID, run any text editor to receive the information.

(3610

elated setup barcodes)